Fire stopping in Wallingford
An old market town on the Thames, with shops below and flats above.
- Every seal labelled and photographed
- BM TRADA / FIRAS-certificated contractors
- Written price before any work
A shop on the ground floor, a narrow stair from the street, one or two flats above, a timber floor between them and a building older than any fire regulation. That is a lot of the centre of Wallingford, and many of those buildings are listed.
The floor between the shop and the first flat carries everything the shop needs: cables, water pipes, a waste from the back kitchen, sometimes an extract duct from a cooker. Lift a ceiling tile at the back of the shop and look up. The holes those services pass through are often open, or packed with whatever was to hand. Fire stopping in a timber floor uses products tested in timber, and the ceiling round the hole may need making good as part of the job.
The stair to the flats is the escape route. Look for cables passing into the shop through the stair wall, and old doorways between the two boarded on one side only.
Where a building is listed, work that affects its character may need listed building consent from South Oxfordshire District Council. Most fire stopping can be done from above or from inside cupboards and boxings without touching historic finishes, and we tell you before pricing if not. Our BM TRADA / FIRAS-certificated contractors cover Wallingford from Reading.

Send the postcode, the type of building and a photo of the gap with a tape measure in the shot. We reply with what it needs and a written price.